04 SSR 5.3L LM4 Vortec Engine Auto Trans Rolling Chassis Full Frame Donor – Refreshed Engine

$9,499.00

1 in stock

SKU: 22-080 ENG Categories: ,

Description

CLEVELAND POWER AND PERFORMANCE IS PROUD TO OFFER THIS 2004 CHEVROLET SSR AUTO TRANS ROLLING CHASSIS! THIS CHASSIS IS COMPLETE WITH ENGINE, TRANS, SUSPENSIONS, FUEL SYSTEM, BRAKE SYSTEM AND MORE. THE 116″ WHEELBASE MAKES THIS SETUP AN IDEAL CANDIDATES TO PUT UNDER YOUR CLASSIC CHEVY PICKUP. THIS CHASSIS WAS REMOVED FROM AN SSR WITH 125K MILES ON IT!

 

DUE TO THE HIGH MILAGE ON THIS TRUCK, THE ENGINE WAS TAKEN DOWN TO A LONG BLOCK TO BE INSPECTED, CLEANED, AND REGASKETED. WE REPLACED ALL NON REUSABLE HARDWARE AND GASKETS IN THE PROCESS. WE ALSO REPLACED THE TIMING SET, EXHAUST MANIFOLD BOLTS, FLEXPLATE BOLTS, AND BALANCER BOLT. 

 

THIS ROLLING CHASSIS FEATURES A 5.3L LM4 VORTEC ENGINE AND 4L60E 4 SPEED AUTO TRANSMISSION! THE 5.3L PRODUCES 300HP @ 5,200 RPM AND 330 FT-LBS OF TORQUE @ 4,000 RPM!

 

HERE IS THE VIN FROM THIS SSR – 1GCES14P64B110462

 

THIS CHASSIS WILL INCLUDE THE FOLLOWING:

5.3L ENGINE

AUTO TRANSMISSION

ENGINE HARNESS 

ENGINE COMPUTER

AIR CLEANER WITH AIR FLOW METER

INSIDE FUSEBOX

OUTSIDE FUSEBOX

IGNITION WITH KEY

PEDALS

SHIFTER

FRAME HARNESS

BODY HARNESS

FRONT SUSPENSION

REAR SUSPENSION

DRIVESHAFT

CALIPERS AND ROTORS

WHEELS AND TIRES  

FUEL TANK AND PUMP

EXHAUST SYSTEM (MODIFIED)

CHARCOAL CANISTER

ABK PUMP AND MODULE

BRAKE BOOSTER

MASTER CYLINDER

BRAKE LINES

FUEL LINES

STEERING COLUMN

EMERGENCY BRAKE HANDLE

STEERING WHEEL

WHEELS AND TIRES – BOTH FRONT WHEELS HOLD AIR, BUT ARE BENT.

BODY MOUNTS

 

At Cleveland Power and Performance, we thoroughly inspect each motor and transmission and then back it with our exclusive 6-month warranty! Before we start each engine, we remove all the spark plugs and hand turn the engine over to make sure no oil has passed the rings. We do a compression test to make sure the rings, valves, and head gaskets are properly sealed. We do a vacuum test to make sure there are no burned or sticking valves, collapsed lifters, or vacuum leaks. We do an oil pressure test at cold start up and warm operating temperatures to ensure proper bearing clearance and that there are no restrictions in the oiling system.
We do a CO test to make sure there are no cracks in the block and heads, and that there are no exhaust gases present in the cooling system. We inspect the automatic transmission by draining and inspecting the transmission fluid. We then remove the filter and check for debris or foreign material. We then refill the transmission with new fluid and run test it through all of the gears to ensure that it shifts properly. If any problems are found, the transmission will be torn down for inspection and repaired as necessary. We also drain the differential and inspect the fluid for debris. We then refill the differential with fluid.

 

BEFORE WE DROPPED THE ENGINE OUT OF THIS SSR, WE DID A FULL RUNTEST.

Compression was 220 over 190

Oil pressure cold 50 pounds

Oil pressure warm 40 pounds

Vacuum draw was 20″

CO check PASSED

 

HERE IS A VIDEO OF US RUNNING THE ENGINE BEFORE REMOVAL

 

Project Blog

2016 Mustang GT w/ 67k

  NEW ARRIVAL: 2016 Mustang GT w/ 67k **5.0L Coyote Manual Turn Key** Rear Bumper Finish Panel Tail Lights Trunk Lid Spoiler 3.31 Rear Diff Radio Grilles Left Headlight[...]
Read More »

1996 Impala SS w/ 55k

  NEW ARRIVAL: 1996 Impala SS w/ 55k LT1 Engine & Trans Hood Grille Headlights Seats Door Panels Lower Dash Dash Pad Steering Wheel Radio Floor Shift Conversion Headliner[...]
Read More »

2004 SSR w/ 109k

  NEW ARRIVAL: 2004 SSR w/ 109k **ROLLING CHASSIS** Running Boards RDM Front Bumper/Headlight Molding Right Fender Right Rear Quarter Seats Dash Trim Door Panels Doors Window Regulator Roof[...]
Read More »

Facebook

Contact

Contact Column

Cleveland Power & Performance is the U.S. leader in late-model auto parts, rolling chassis, restored vehicles and custom auto upholstery.

12420 Station Road, Columbia Station, OH 44028

 
Contact Us Mon-Fri 8am-5pm EST
(866) 236-5031
Email inquiries power@clevelandpap.com
SALES TEAM
MILES - 440-236-4224
TIM - 440-236-4225
MIKE M - 440-236-4223

Get the latest updates from Cleveland PAP

  


Choose Language:

Instagram

© Copyright 2022 Cleveland Power & Performance. All Rights Reserved.
Made with pride in Cleveland, OH USA.