04 SSR 5.3L LM4 Vortec Engine Auto Trans Rolling Chassis Full Frame Donor 108K Miles

$8,499.00

1 in stock

SKU: 22-082 ENG Categories: ,

Description

CLEVELAND POWER AND PERFORMANCE IS PROUD TO OFFER THIS 2004 CHEVROLET SSR AUTO TRANS ROLLING CHASSIS! THIS CHASSIS IS COMPLETE WITH ENGINE, TRANS, SUSPENSIONS, FUEL SYSTEM, BRAKE SYSTEM AND MORE. THE 116″ WHEELBASE MAKES THIS SETUP AN IDEAL CANDIDATES TO PUT UNDER YOUR CLASSIC CHEVY PICKUP. THIS CHASSIS WAS REMOVED FROM AN SSR WITH 108K MILES ON IT!

 

DUE TO THE AGE/MILEAGE ON THIS TRUCK, THE ENGINE WAS TAKEN DOWN TO A LONG BLOCK TO BE INSPECTED, CLEANED, AND REGASKETED. WE REPLACED ALL NON-REUSABLE HARDWARE AND GASKETS IN THE PROCESS. WE ALSO INSTALLED NEW PLUG WIRES, RUBBER MOTOR MOUNTS, TRANS PAN, AND GASKET.

 

THIS ROLLING CHASSIS FEATURES A 5.3L LM4 VORTEC ENGINE AND 4L60E 4 SPEED AUTO TRANSMISSION! THE 5.3L PRODUCES 300HP @ 5,200 RPM AND 330 FT-LBS OF TORQUE @ 4,000 RPM!

 

HERE IS THE VIN FROM THIS SSR – 1GCES14P14B103502

 

THIS CHASSIS WILL INCLUDE THE FOLLOWING:

5.3L ENGINE

AUTO TRANSMISSION

ENGINE HARNESS 

ENGINE COMPUTER

AIR CLEANER WITH AIR FLOW METER

INSIDE FUSEBOX

OUTSIDE FUSEBOX

IGNITION WITH KEY

PEDALS

SHIFTER

FRAME HARNESS

BODY HARNESS

FRONT SUSPENSION

REAR SUSPENSION

DRIVESHAFT

CALIPERS AND ROTORS

WHEELS AND TIRES  

FUEL TANK AND PUMP

EXHAUST SYSTEM W/ MAGNAFLOW MUFFLER

CHARCOAL CANISTER

ABK PUMP AND MODULE

BRAKE BOOSTER

MASTER CYLINDER

BRAKE LINES

FUEL LINES

STEERING COLUMN

EMERGENCY BRAKE HANDLE

STEERING WHEEL

WHEELS AND TIRES (AFTERMARET CENTER CAPS)

BODY MOUNTS

 

At Cleveland Power and Performance, we thoroughly inspect each motor and transmission and then back it with our exclusive 6-month warranty! Before we start each engine, we remove all the spark plugs and hand turn the engine over to make sure no oil has passed the rings. We do a compression test to make sure the rings, valves, and head gaskets are properly sealed. We do a vacuum test to make sure there are no burned or sticking valves, collapsed lifters, or vacuum leaks. We do an oil pressure test at cold start up and warm operating temperatures to ensure proper bearing clearance and that there are no restrictions in the oiling system.
We do a CO test to make sure there are no cracks in the block and heads, and that there are no exhaust gases present in the cooling system. We inspect the automatic transmission by draining and inspecting the transmission fluid. We then remove the filter and check for debris or foreign material. We then refill the transmission with new fluid and run test it through all of the gears to ensure that it shifts properly. If any problems are found, the transmission will be torn down for inspection and repaired as necessary. We also drain the differential and inspect the fluid for debris. We then refill the differential with fluid.

 

BEFORE WE DROPPED THE ENGINE OUT OF THIS SSR, WE DID A FULL RUNTEST.

Compression was 195 over 175

Oil pressure cold 50 pounds

Oil pressure warm 40 pounds

Vacuum draw was 20″

CO check PASSED

 

HERE IS A VIDEO OF US RUNNING THE ENGINE BEFORE REMOVAL

 

Project Blog

2011 Camaro SS w/ 111k

  NEW ARRIVAL: 2011 Camaro SS w/ 111k **LS3 Engine & 6 Speed Manual Trans Turn Key** Seats Wheels Rear Bumper Tail Lights Door Panels Console 3.45 Rear Differential[...]
Read More »

NEW ARRIVAL: 1968 Ford LTD

NEW ARRIVAL: 1968 Ford LTD
Read More »

2002 C5 Corvette w/ 44k

  NEW ARRIVAL: 2002 C5 Corvette w/ 44k **LS1 Auto Rolling Chassis or Go Kart** Sport Seats Left Door Left Quarter Left Door Mirror Left Fender Headlights Radio Dash[...]
Read More »

Facebook

Contact

Contact Column

Cleveland Power & Performance is the U.S. leader in late-model auto parts, rolling chassis, restored vehicles and custom auto upholstery.

12420 Station Road, Columbia Station, OH 44028

 
Contact Us Mon-Fri 8am-5pm EST
(866) 236-5031
Email inquiries power@clevelandpap.com
SALES TEAM
TIM - 440-236-4225
MIKE M - 440-236-4223

Get the latest updates from Cleveland PAP

  


Choose Language:

Instagram

© Copyright 2022 Cleveland Power & Performance. All Rights Reserved.
Made with pride in Cleveland, OH USA.